Air Source Heat Pump Installation Plymouth

Every heat pump installation we do in Plymouth is done by the same team from start to finish. On a lot of jobs the heating engineer fits the unit, then leaves, and the customer is told to find their own electrician to wire it in. Alan is Gas Safe registered, F-Gas certified and an NICEIC Approved Contractor. One firm, one visit, one bill. Read the full page.

Almost every heat pump customer we work with gets the government grant, currently £7,500. You do not have to deal with any of it. We handle the paperwork, the heat loss calculations and the application on your behalf, and the quote arrives with the grant already taken off. Read the full page.

An air to water heat pump feeds your existing wet system, so radiators, underfloor heating and the hot water cylinder all run from it. For most Plymouth homes coming off a gas or oil boiler this is the type we fit. We will tell you honestly which radiators need upsizing, and it goes in the quote.

We fit air source heat pumps in Victorian and Edwardian terraces around Plymouth, post war semis and estate housing in Plympton, Plymstock and Ivybridge, new builds and self builds across the South Hams, rural properties around Tavistock, Launceston and Looe coming off oil, and commercial premises including work for Cornwall Council on their buildings.

For the right property, ground source draws heat from buried pipework instead of the air, giving a steadier source through the winter. It needs land and groundworks. Read the full page.

Daikin certified installer, reference CI35. That certification is not a sticker. It means we are trained on the equipment, we can get parts and technical support quickly, and your warranty is protected because the install was done to the manufacturer’s standard. We also install Mitsubishi, Toshiba, Hitachi and Kensa systems where they suit the property better.

A heat pump needs an annual service, the same as a boiler. It keeps the efficiency up, keeps your running costs down, and it keeps the manufacturer’s warranty valid. We service every major make, whether we fitted it or not. Read the full page.

Heat pump not heating, making a noise, or throwing a fault code? We are F-Gas certified for fault finding, re-gassing and repair, with a fast local response across Plymouth and the surrounding area.

If you already have a heat pump that is old, undersized or was never right from the day it went in, we can replace it with a modern high efficiency unit. Grant help may be available depending on your circumstances.

Most heat pump installations need a new hot water cylinder, because a heat pump heats water to a lower temperature than a boiler and needs more storage. We supply, install and service unvented cylinders as part of the job.

Air source is one option. For the right property we also fit ground source heat pumps, and we can advise on underfloor heating, which pairs well with a heat pump because it runs at a lower flow temperature. If a heat pump is not right for your house, we will say so.

A typical domestic air source heat pump installation in Plymouth works out between £4,000 and £5,000 after the grant, depending on the size of the property and how much work the existing system needs. You get a written, itemised quote after the survey. No pressure, and no charge for the visit.

Plymouth, Plympton, Plymstock, Ivybridge, Tavistock, Kingsbridge and the South Hams, Looe, Launceston, Okehampton, Bodmin and St Austell.