Thermostat Repair Plymouth
Thermostat and heating control repair in Plymouth. HPE Airflow SW Ltd repairs room thermostats, programmers, cylinder thermostats, radiator valves, smart controls and heat pump controllers.
NICEIC Approved Contractor and Gas Safe registered, so we can work on both the wiring and the heating system it controls. That matters, because a control fault and a heating fault look identical from the hallway.
Is it the thermostat or the heating?
This is the question worth answering before anyone starts replacing parts, and it is where money gets wasted.
A thermostat that calls for heat but gets none points at the boiler, heat pump or wiring. A thermostat with a blank screen or unresponsive buttons is usually the thermostat, or its batteries. Heating that runs constantly and will not switch off is often a stuck valve rather than the thermostat. A house that never reaches the set temperature may be a control fault, or may simply be a system that cannot deliver enough heat.
We diagnose before we replace. Swapping a working thermostat because the symptom appeared there is a common and avoidable cost.
Common faults
Blank or frozen display. Batteries first, then power supply, then the unit itself.
Lost connection on a wireless thermostat. Re-pairing usually solves it. Where it keeps dropping out, the receiver or the position is at fault.
Reading the wrong temperature. Sometimes a failed sensor. More often the thermostat is in the wrong place, above a radiator, in direct sun or next to a draught.
Timer no longer holding its programme. Typically a failing internal battery on an older programmer.
Radiator valves stuck. Thermostatic valve pins seize, usually in the open position after a summer untouched. Often freed rather than replaced.
Cylinder thermostat failed. Shows up as hot water that is either lukewarm or scalding.
Smart thermostat offline. Sometimes the network rather than the heating. We will tell you which.
Heat pump controllers
Heat pump controls are more involved than a boiler thermostat, and faults here are often not faults at all but settings that were never configured properly.
Weather compensation left disabled, a fixed flow temperature set far too high, or schedules that switch the system hard on and off as though it were a boiler. Each of those makes a perfectly healthy heat pump expensive to run, and each is corrected rather than repaired.
Where there is a genuine controller or sensor failure we will find it. See also heat pump repair.
What a thermostat repair costs
Most control faults are resolved in a single visit, and a good proportion of them cost far less than people expect because the thermostat was never the problem.
We charge for the visit and the parts, and we tell you the likely cost before we start rather than after. If we find the fault in ten minutes, that is what you pay for. If tracing an undocumented wiring centre in a house that has been altered three times takes longer, we will say so while we are there and you can decide.
Where we can, we fix on the first visit. We carry common room stats, receivers, actuator heads and cylinder stats, which covers the large majority of what we find. Obsolete or manufacturer specific controllers occasionally need ordering, and we will tell you the lead time honestly rather than leaving you without heating on a vague promise.
One thing worth saying plainly: if you have been quoted for a complete new control system when your only symptom is intermittent heating, get a second opinion. That is frequently a seized valve or a failed receiver, and the difference in price is considerable.
Rentals, holiday lets and empty properties
A good part of our control work around Plymouth and the South West is for landlords and holiday let owners, and the requirements are different from a family home.
In a let property the priority is a control that a tenant or a guest cannot break, cannot run at 28 degrees for a fortnight, and does not need an app or an account to operate. Simple, robust and legible beats clever. We are happy to fit a basic programmable stat and lock the settings rather than sell you something with more features than the property needs.
Holiday lets on the coast, around Looe and the South Hams, bring a second problem: long empty spells in winter. Frost protection that actually works matters more than the difference between one thermostat and another, and it is worth checking that yours is set rather than assuming it.
If the property also needs a gas or electrical safety check while we are there, we can do both in the same visit. See landlord safety certificates.
Wireless or wired
When a thermostat needs replacing rather than repairing, the first question is usually whether to go wireless, and the answer depends more on your house than on the thermostat.
Wireless is the obvious choice in a retrofit. There is no cable to run, so the stat can go where it should be rather than where the old wiring happens to arrive, and in a solid walled house that avoids chasing plaster. It also means the stat can be moved later if the room use changes.
The trade off is that a wireless stat has batteries and a radio link, and both are things that can fail. Batteries are a five minute job once a year. The link is generally reliable, but thick stone walls and long distances can cause dropouts, and a stat that loses its pairing looks exactly like a broken boiler.
Wired is more robust and never needs a battery. In a new build, a renovation with the floors up, or where the cable already exists, it is usually the better answer.
The one situation where we would push you towards wired is a let property, because a tenant reporting no heating on a Sunday, when the actual fault is a flat battery, costs everybody a wasted visit. See thermostat installation.
Repair or upgrade
Plenty of control faults are worth repairing, and we would rather do that. Batteries, sensors, receivers, seized valve pins and wiring faults are all straightforward.
Where a very old programmer has failed and parts are no longer available, replacement is the practical answer, and it is usually an opportunity to improve the controls rather than simply restore them. See thermostat installation.
We will not tell you a repairable control needs replacing.
Thermostat repair questions
Batteries first, then the power supply, then the unit itself. A surprising number of blank-display callouts are a flat battery.
That is the question worth answering before anyone replaces parts, and it is where money gets wasted. We diagnose which it is rather than swapping the thermostat and hoping.
Most control faults are resolved in a single visit, and a good proportion cost far less than a replacement. We give you the price before we start.
Wireless avoids running new cable and is usually the practical choice in an occupied house. Wired is more robust where the cabling already exists. We will advise based on your property.
Yes. A good part of our control work around Plymouth is for landlords and holiday lets, including properties standing empty between bookings.
Plymouth and the surrounding towns, including Saltash, Ivybridge, Tavistock, Callington, Liskeard and Torpoint.
Book a visit
Call 07789 373208 or send an enquiry. Describe what the heating is doing as well as what the thermostat is doing, because the two together usually identify the fault.
If the heating itself is at fault, see heating system repair. We cover Plymouth and the surrounding towns. Email info@airflowsouthwest.co.uk